Eltax AVR-320 - Manual (Page 13)

13
REMOTE CONTROL UNIT
REMOTE CONTROL
By using the provided remote control unit, this unit can be
controlled from your listening position. To use the remote control
unit, point it at the REMOTE SENSOR window of this unit.
Notes:
- Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.
- If the remote control unit is operated near other appliance which
generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly.
- The power is turned on/off (standby) by pressing the POWER
button on the remote control unit in standby mode.
Precautions concerning batteries
- Be sure to insert the batteries with correct positive+ and
negative – polarities.
- Use batteries of the same type. Never use different types of
batteries together.
- Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
- When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking. If they leak, wipe away
the liquid inside the battery compartment and replace the
batteries with new ones.
- Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
BATTERY INSTALLATION
1. Remove the battery compartment cover.
2. Insert two “AAA” dry batteries. Make sure that the batteries
are inserted with their positive “+” and negative “-” poles
positioned correctly.
3. Close the cover until it clicks.
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this
case, replace the batteries with new ones.