Eltax AVR-320 - Manual (Page 16)

16
BASIC OPERATION
BASIC OPERATION 1
1. Press the POWER button to put this unit into Standby Mode.
2. Press one of the source buttons to activate the unit.
3. Select the desired source by pressing DVD, VIDEO 1, VIDEO 2, TUNER, AUX or TAPE.
If you have selected DVD, VIDEO 1, VIDEO 2 (not TUNER, AUX or TAPE), press INPUT MODE, SURROUND MODE, DTS/DOLBY
DIGITAL, STEREO, DOLBY PROLOGIC II or DIGITAL IN in accordance with the type of signal you are receiving and the sound output
you require (for example, Dolby Pro Logic II if the DVD movie is an older "classic" and only recorded in stereo).
4. Play the source, and gradually turn up the volume to the required level with the VOLUME control.
BASIC OPERATION 2
A. POWER button
Press this button to turn this unit into standby mode, then the STANDBY indicator lights up, press one of the source buttons to activate
this unit, the standby indicator goes out when this unit is turned on.
B. SURROUND MODE
This mode is used to achieve a realistic sound field with a “three-dimension”, giving the sense of distance, movement and relative
position, creating a real and powerful sense of presence.
C. STEREO
In the STEREO mode, only the Front Left and Front Right speakers and Subwoofer are activated.
D. DOLBY PRO LOGIC II
Pro Logic II uses a directional emphasis circuit to decode five output channels (Front Left & Front Right, Centre and Surround) from a
stereo audio channel.
E. DTS/DOLBY DIGITAL
When playing 5.1CH source, and while you are enjoying Stereo, press this button to playback source in DTS/DOLBY DIGITAL.
F. PHONES JACK
For private listening, insert your headphones (1/4 –inch plug) into the PHONES jack. The centre and surround speakers will be cut
automatically.
Note: When using headphone, the audio output will automatically down mix to STEREO.