Hotpoint EG21 & EG22 - Manual (Page 26)

Unpack the components from inside the grill and oven: Check that
the following parts are present.
Grill pan and grid Grill pan handle
Baking dish Pan supports (2)
Oven shelves (2) Enamelled discs (4)
Literature Brass burner port rings (4)
Aluminium burner bodies (4)
The cooker must be fitted with a stability device firmly secured to the
fabric of the building. The M6 bolt at the top of the rear of the cooker
can be used to engage a stability chain. Keep the chain clear of
controls and pipes on the rear of the cooker.
The chain must be fitted to the wall behind the cooker.
The cooker is designed to match the depth of standard 600mm work-
tops. An adaptor backplate should, therefore, be fitted within the
shaded area shown to allow the cooker to be pushed fully to the wall.
If a forward facing backplate is used, it must be chased into the wall.
Connection to the cooker should be made with an approved
appliance flexible connection to BS 669. A length of 0.9 to 1.25m is
recommended. The length of hose chosen should be such that when
the cooker is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are likely
to come in contact with the flexible hose do not exceed 70
o C.
530
300
200
Installation
26
Unpacking the
Cooker
Stability Chain
Connecting To
The Gas Supply
300
250
530