Specifications, Bulb replacement – Heath Zenith SL-4290 Series User Manual

Page 6

Advertising
background image

6

598-1277-02

If you need to change the sensitivity,

temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.

Set the amount of TIME you want the light

to stay on after motion is detected. (1, 5,
or 10 minutes).

Set the amount of time after dusk you want

the lights on accent level.

SPECIFICATIONS

Range .........Up to 30 ft. (9.1 m) [varies with

surrounding temperature].

Sensing Angle ............................Up to 150°
Electrical Load .... Up to 100 Watt Maximum

Tungsten Incandescent

Sensor Capacity ..... Up to 360 Watt (3.0 A.)

Maximum Tungsten

Incandescent

Power Requirements ......... 120 VAC, 60 Hz
Operating Modes ............ TEST, AUTO, and

MANUAL MODE

Time Delay ........................ 1, 5, 10 minutes
D

ual

B

rite

®

timer ...................... Off, 3, 6 hrs,

Dusk-to-Dawn

Walk through the coverage area noting

where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area.

Rotating Sensor Head to Change

Coverage Area

IMPORTANT: Grasp the sensor only as
shown and turn the entire sensor. Any
other method may damage the sensor.
Do not force the sensor past the stop-
ping points.

15

150

°

BULB REPLACEMENT

If lantern has an open bottom, insert bulb
through opening and screw into socket.
If lantern has a closed
bottom, follow the steps
below to replace bulb.
1. Place one hand

under lower glass
assembly and un-
screw decorative
screws

holding

lower glass as-
sembly to top of
fixture.

2. Replace bulb.
3. Reattach

lower

glass assembly
to fixture top us-
ing

decorative

screws.

Decorative Screws

Lower Glass

Assembly

Light
Bulb

Advertising