HONDA ODYSSEY Security System - Manual (Page 10)

10 © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Arming
Arming Methods
There are two possible ways to arm the system:
• MANUAL Arming (Remote Control)
• AUTOMATIC Arming (Passive)
Manual Arming
(Remote Controlled)
1 Make sure the arming mode is set to MANUAL.
Turn the ignition key to the LOCK (0) position.
Remove the key from the ignition switch.
Exit the vehicle, then close all the doors and
the tailgate.
Press the LOCK button on the remote control
transmitter. Observe that:
• The remote control LED illuminates.
• The security system starts to arming delay.
• The status LED flashes once per second.
(Be sure to check the status LED flashes.)
• The parking lights flash once. (Be sure to
check that the lights flash.)
• The doors lock.
• After 15 seconds, the security system arms itself.
• The status LED flashes once per 3 seconds.
(Be sure to check the status LED flashes.)
If the LOCK button is pressed a second time
(within 5 seconds of the first push) the horn
beeps once to confirm the doors are locked
and the system is armed.
2
3
3
• When the main unit is set to MANUAL, the system is armed by using the remote control
transmitter. This is the factory setting.
• The system beeps three times. It does not arm itself unless any door or the tailgate is
closed when the LOCK button is pressed.
4625030B