Halfords Bicycle Accessories - Manual (Page 6)

9A. Tighten the bike hub nut securely with a wrench.
9B. Locate the front end of the tow bar around the coupler.
9C. Push the quick release pin through the holes in the tow bar and the coupler and fasten securely.
9D. Loop safety strap around bike frame and clip the end into the “D” ring at the end of the tow bar.
WARNING Safety strap must be attached to the bike frame when using this product in trailer mode.
STEP 10 Coupler attachment for bikes with quick-release rear axles.
10A 10B 10C 10D
10A. Flip open the quick-release lever, and remove the nut and spring from the opposite side.
10B. Hold the lever and pull the axle skewer with spring out.
10C. Completely remove the skewer but leave the wheel in place.
10D. Slide the coupler plate and tab washer onto the skewer. IMPORTANT! The larger diameter end of the conical
spring should face outwards, towards the QR lever.
STEP 11 Attach trailer tow bar to bike
11A 11B 11C 11D
11A. Insert end of skewer back through wheel hub.
11B. Replace the spring (wide end out) over the end of the skewer, followed by the nut. Tighten the nut by hand
and clamp the lever down (F).
11C. Insert the end of the trailer tow bar into the large hole and fasten the Q/R pin.
11D. IMPORTANT! Loop the safety strap around the bike frame and clip the end into the “D” ring at the end of the
tow bar (H).
WARNING Safety strap must attach to the bike frame when using this product in trailer mode.
STEP 9 Attach trailer tow bar to bike
9A 9B 9C 9D