Heath Zenith Motion sensing Pendant Light 4350 - Manual (Page 3)

3 598-1219-05
instaLL universaL MOunting
Bracket
Canopy Screw (x3)
(Tightened Finger
Tight)
Junction Box
Universal Mounting
Bracket
Mounting Bracket
Screw (x2)
asseMBLe canOPy
1. Determine the number of mounting rods needed
to mount the pendant light. Any combination of
the 3 mounting rods may be used. Note: For
best performance, mount the fixture so that the
sensor is between 8 and 10 feet (2.4 m) above
the ground.
2. Determine which mounting rod will connect to
canopy.
3. Locate the 1" (25.4 mm) threaded rod.
4. Connect the end of the threaded rod with the
thread sealant to the mounting rod that will
connect to the canopy. Hand tighten securely.
Note: Excess sealant may have to be trimmed
away for best appearance.
5. Place the small, thick, decorative washer onto
the threaded rod.
6. Place the decorative flat washer onto the
threaded rod.
7. Place canopy onto threaded rod.
8. Place the other large washer onto the threaded
rod.
9. Place the S-Hanger Terminal onto the threaded
rod with tab facing away from canopy.
10. Place star washer onto threaded rod.
11. Screw nut onto threaded rod and tighten se-
curely with wrench.
Nut
Star Washer
S-Hanger Terminal
Flat Washer
Canopy
Decorative Flat Washer
Small, Thick,
Decorative Washer
1" (25.4 mm) Threaded Rod
Mounting Rod
End with Thread
Sealant
WARNING: Turn power off at circuit
breaker or fuse.
1. Remove universal mounting bracket from canopy
by removing the 3 knurled canopy nuts.
2. Tighten the three canopy screws finger tight.
3. Attach universal mounting bracket to junction
box securely with the two screws provided.