Heath Zenith Motion sensing Pendant Light 4350 - Manual (Page 5)

5 598-1219-05
Knurled
Canopy Nut
testing
1. turn on the circuit breaker and light
switch.
Note: Sensor has a 1 1 /
2
minute warm up period
before it will detect motion. When first turned on
wait 1
1 /
2
minutes.
2. To remove sensor cover, unscrew the 4 sen-
sor cover screws holding the sensor cover on
bottom of light fixture.
instaLL Pendant Light tO
JunctiOn BOx
1. Push wires into the junction box.
2. Remove S-Hanger.
3. Slide canopy onto canopy screws and tighten
knurled canopy nuts securely against the
canopy. Note: Canopy should fit tight against
mounting surface.
Canopy Screw
Canopy
BuLB instaLLatiOn and
rePLaceMent
1. Slide door latch up to unlock door. Pull latch to
open door.
2. Install two candelabra base light bulbs (60
Watts maximum each).
3. After installing bulbs, close door and slide latch
down to securely lock door.
DUAL
BR ITE ®
ON-
TIM E
TES
T 1 5
10 MI
N
OFF
3 6
DUSK
TO
DAWN
DUAL
BR ITE ®
ON-
TIM E
TES
T 1 5
10 MI
N
OFF
3 6
DUSK
TO
DAWN
Lift Latch Up Open Door
3. Set the ON-TIME switch to the TEST position and
the D
ual
B
rite
® switch to the OFF position.
DU AL BRIT E ®
ON- TIME TE ST 1 5 10 MI N OFF 3 6 DU SK
TO DA WN
Sensor
Sensor Cover
Sensor Cover
Nut
DUAL BR ITE ®
ON- TIME TEST
1 5 10 MI
N OFF 3 6 DU SK
TO DAWN
DualBrite ®
ON-TIME
DUSK
OFF 3
HR
6
HR
TO DAWN
TEST 1 5 10 MIN
Sensor
Lens
4. Walk through the coverage area noting where
you are when the lights turn on. In TEST mode,
light will stay on for only 5 seconds then turn
off.