Heath Zenith Wireless Chime 6153 - Manual (Page 2)

-2- 595-5611-07
6. Mount push button. Use either screws or double
sided tape to mount push button.
•
Screw Mounting: To mount with screws, remove
back of case by pushing in tab on bottom with a small
screwdriver (see Figure 1). Note: Remove material in
screw holes (if needed) before mounting with screws.
Attach back of case to door jamb or wall (see Figure
4). Snap front of push button on.
• Tape Mounting: When attaching push button using
double sided tape, make sure the surface of the door
jamb or wall is clean.
7. Mount chime. Chime can be mounted by using 3
holes in the back of case, or by using 2 screws with
keyholes.
Keyhole Mounting: Determine mounting location.
• Mark two hole locations. Note: Make sure holes are level before drilling.
• Models 6153 and 6162 (see Figure 5): 3-5/16" (8.4 cm) apart.
• Models 6171 and 6172 (see Figure 5): 2-3/8" (6 cm) apart.
• Drill two 7/32" diameter pilot holes for wall anchors and insert anchors.
• Mount keyhole screws to wall leaving about 1/8" (3 mm) of the screw threads
exposed.
• Snap cover onto chime base.
• Models 6153 and 6162: Align top edge of case with top of back plate. Rotate
bottom of case toward back plate and snap into position (see Figure 7).
• Models 6171 and 6172: Align bottom edge of case with bottom of back
plate. Rotate top of case toward back plate and snap into position (see
Figure 7).
• Using keyholes on back of chime base, hang base on screws (see Figure 5).
Screw Mounting: Determine mounting location.
• Place chime against wall and verify the chime is level.
• Use chime holes as a template (see Figure 6). Drill three 7/32" diameter pilot
holes for wall anchors (provided) and insert anchors.
• Insert 3 screws (provided) through holes in back of chime.
• Verify chime is level and tighten screws securely.
• Snap cover onto chime base.
• Models 6153 and 6162: Align top edge of case with top of back plate. Rotate
bottom of case toward back plate and snap into position (see Figure 7).
• Models 6171 and 6172: Align bottom edge of case with bottom of back
plate. Rotate top of case toward back plate and snap into position (see
Figure 7).
Figure 4