haier IPDS-10 - Manual (Page 13)

12
TROUBLESHOOTING GUIDE
Soluti on
iPod Player
Plug the AC adaptor into a wall
outlet and plug the connector
into the DC IN jack on the unit. AC adaptor is not plugged into a
wall outlet or the connector is not
plugged into the DC IN jack on
the back of the unit.
Using no or wrong iPod insert
iPod did not install properly
iPod is not installed properly
iPod is locked up
Using first or second generation
iPod, iPod shuffle or other
devices.
iPod is not installed properly
iPod is locked up/frozen
iPod battery has problem
Unit does not respond
(no power)
iPod does not dock
properly
iPod does not
respond to the unit
iPod did not
charge up
Make sure the dock insert is
the proper fit for the iPod.
Remove the iPod from the dock
and check for obstruction on the
connections in the dock and on the
iPod. Then reseat it in the dock.
Remove the iPod from the dock
and check for obstruction on the
connections in the dock and on the
iPod. Then reseat it in the dock.
Please make sure your iPod is
working properly before docking
into the unit. Please refer to the
iPod manual for details.
This unit cannot control those
iPod or other devices.
Remove the iPod from the dock
and check for obstruction on the
connections in the dock and on the
iPod. Then reseat it in the dock.
Please make sure your iPod is
working properly before docking
into the unit. Please refer to the
iPod manual for details.
Remarks:
If troubleshooting(see above)does not eliminate the problem, disconnect the unit from the
mains power and re-connect after a few seconds. Resetting causes the unit to restore its factory
default setting and results in all the setting made by the user being deleted.
Symptom Possible Cause