How do i set preferences, Units of measurement, Loading preferences – HP 815MFP User Manual
Page 50: Scan and user interface options
44
hp designjet 815mfp & scanner 4200
how do I set preferences?
units of measurement
Before setting any size parameters, you should determine the unit of
measurement (millimeters, centimeters, or inches) you prefer to use
throughout the application.
To set your preference of size measurement units:
1. Press the Setup tab.
2. Press the Options button and then the Units of Measure button.
3. Select the preferred units:
millimeters, centimeters, or
inches.
loading preferences
To set loading preferences:
1. Press the Setup tab.
2. Press the Scan Options button
and then the Load button.
3. Select Center or Side loading:
• Center loading: an arrow
on the scanner marks the
center point. Insert your
original so that its center is
aligned with the arrow.
Standard sizes are marked
along the insertion slot.
• Side loading: the edge of
the document is inserted so
that it is aligned with the zero point (marked ‘0’ on the
ruler) at the right-hand side of the scanner’s insertion slot.
see
how do I define scanner setup options? on page 39
scan and user interface options
1. Press the Setup tab.