Harbor Freight Tools 92966 - Manual (Page 4)

Page 4 SKU 92966 for technical questions, please call 1-800-444-3353.
(up to 50 feet), with wire size rated at 18 AWg. Longer extension cords require larger
size wire.
Maintenance. For your safety, service and maintenance should be performed regularly
by a qualified technician.
people with pacemakers should consult their physician(s) before using this
product. Electromagnetic fields in close proximity to a heart pacemaker could cause
interference to or failure of the pacemaker.
Keep hands away from the needle when you turn the power switch on, or while
the machine is operating.
Do not place your fingers into the thread take-up cover while the machine is
operating.
During operation, never place your head, hair, or hands in the proximity of the
hand wheel, V-belt, bobbin winder, or motor.
Do not operate the machine with any safety guards removed.
this machine shall only be operated by appropriately trained operators.
for your personal protection, we recommend you wear ANSi-approved safety
glasses when using the machine.
if oil or grease comes in contact with your eyes or skin, immediately wash the
affected areas and consult a physician.
tampering, modifying or altering any device (aside from the cord and plug by a
licensed electrician) on the machine is prohibited and will void manufacturer’s
warranty.
Repair, adjustment, and specific maintenance shall only be performed by a quali-
fied service technician. Alteration or replacement of the 3 prong grounded electrical
plug provided with the machine must only be performed by a licensed electrician. This
machine must be properly grounded.
Note: Performance of this tool may vary depending on variations in local line voltage. Extension
cord usage may also affect tool performance.
Warning: the warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. it must be understood
by the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
unpacking
When unpacking, check to make sure that the parts shown in the photo on the following
page are included. Note that the machine table shown is not included, and must be ordered
separately. If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual as soon as possible.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.