Husqvarna TS 66 R - Manual (Page 31)

23
English
• No adjustment is necessary. This is carried out in
our workshops.
10 Adjustments
11 Maintenance (the motor must be stopped)
• Clean the machine daily.
• Empty regularly the tank to remove muddy depo-
sits which could clog the pump and thus cause
premature wear.
• Wash the tray with plenty of water.
• Clean the pump.
• Store in a dry place
• Clean the rails with particular attention.
Store in a dry place, not accessible to
children.
Maintain the tools carefully.
Before carrying out any operation
disconnect the machine from the
mains
FAULT FINDING
In the event of faulty operation refer to the tables
below to find a solution.
CAUSES
• The machine does not work
Not plugged in proper-
ly or cable damaged
No mains voltage
Switch defective,
motor cable damaged
Motor faulty (no
power, unpleasant
smell)
- Make sure that the
supply is correctly
plugged in (plug,
extension lead, etc)
- Check the supply
cable
- Test or have tested
by an electrician (cir-
cuit breaker, plug,
etc)
- Have tested by an
electrician or contact
the service depart-
ment
- Contact the service
department to have
the motor replaced
REMEDIES
CAUSES REMEDIES
• Difficult starting
Single phase motor
starting condenser - Replace the conden-
ser
CAUSES REMEDIES
• The pump does not start
The mains lead is not
correctly connected or
is damaged
No voltage in pump
circuit or mains supply
circuit
- Check the mains
lead
- Check the pump cir-
cuit and mains sup-
ply circuit
REMEDIES
• The pump does not pump water
CAUSES
- Holding the pump of
the outlet pipe remove
it from the water and
reimmerse it
- Unscrew the filter
and, using a small
screwdriver, remove
all dirt from the ope-
rating area of the tur-
bine.
An air bubble may have
formed inside the pump
body
The turbine is jammed