HP 35s Scientific Calculator - Manual (Page 254)

16-8 Statistics Programs
Flags Used:
Flag 0 is set if a natural log is required of the X input. Flag 1 is set if a natural log is
required of the Y input.
If flag 1 is set in routine N, then I001 is executed. If flag 1 is clear, G001 is
executed.
Program instructions:
1. Key in the program routines; press  when done.
2. Press  and select the type of curve you wish to fit by pressing:
S for a straight line;
L for a logarithmic curve;
E for an exponential curve; or
P for a power curve.
3. Key in x–value and press  .
4. Key in y–value and press  .
5. Repeat steps 3 and 4 for each data pair. If you discover that you have made
an error after you have pressed  in step 3 (with the value prompt still
visible), press  again (displaying the value prompt) and press
U to undo (remove) the last data pair. If you discover that you
made an error after step 4, press U . In either case, continue at
step 3.
6. After all data are keyed in, press R to see the correlation
coefficient, R.
7. Press  to see the regression coefficient B.
8. Press  to see the regression coefficient M.
9. Press  to see the value prompt for the , –estimation routine.
10. If you wish to estimate based on x, key in x at the value prompt, then
press  to see ().
11. If you wish to estimate based on y, press  until you see the value
prompt, key in y, then press  to see ().
12. For more estimations, go to step 10 or 11.
xˆ yˆ
yˆ
yˆ
xˆ
xˆ