Harman Stove Company TL2.0 - Manual (Page 28)

28
TL2.0 Woodburning Stove
Dry Seasoned Wood Only! Save These Instructions 3-90-08560
B. general Maintenance Procedures
1. ash Removal
• frequency: As needed / Every day or two
• By: User
Wear Leather gloves To Prevent skin Burns!
Open the ash removal door by lifting upward on the
latch handle, then swing the door open. Pull the ash
pan out of the firebox, using the lip on the front of the
pan. Once the ash pan is removed from the stove, you
can flip the carry handle up for convenience.
If removing ashes while a fire is burning, close and
latch the ash door while disposing of the ashes.
DO NOT leave the appliance unattended with the ash
door open.
dIsPOsaL Of asHEs;
ashes should be placed in a steel container with
a tight fitting lid. the container of ashes should
be moved outdoors immediately, and placed on
a noncombustible floor or the ground, well away
from all combustible materials, pending final
disposal. if the ashes are disposed of by burial in
soil or otherwise locally dispersed, they should be
retained in the closed container until all cinders
have completely cooled. other waste shall not be
placed in this container.
2. door glass
• frequency: As needed / Weekly
• By: User
Whenever the view of the fire is obstructed, or weekly,
clean the glass using a soft cloth dampened with
standard household glass cleaner.
CauTION! dO NOT CLEaN gLass WHEN HOT.
allow glass to cool before cleaning.
fly-ash allowed to accumulate on the glass may
lead to permanent fogging or "crazing" of the
glass.
Inspect the glass and sealing gasket. Replace gasket
as needed. Do not operate the stove with a broken
glass. Replacement glass, which is ceramic glass,
should be obtained only through your Harman dealer.
To replace a broken glass; first be sure to carefully
remove the broken glass and any remaining shards or
pieces. With the door laying on a flat surface, lay the
gasketted glass panel onto the door and be sure it is
properly fitted into the channel. Lay the glass retainer
clips in place near each corner, and secure them using
the 3/8" screws. Be sure to tighten each screw equally
so you don't create a pressure point on the glass.
warning! Do not use substitute material for
glass Replacement.
CAUTiON: Never USe AbrASive MATeriALS
ON The gLASS.
WaRNINg: dO NOT aBusE gLass By sTRIkINg
OR sLaMMINg THE dOOR CLOsEd. THIs TyPE Of
BREakagE Is NOT COvEREd By THE PROduCT
WaRRaNTy.
Glass Retainer
screws
Glass Panel
Glass Gasket
Glass Retainers
Door Frame
glass specifications: 5mm x 419mm x 314mm arched.