Hearth and Home Technologies IntelliFire Plus Multifucntion Remote RC300 - Manual (Page 2)

Hearth & Home Technologies • RC300 Multifunction Remote Control • 2166-393 Rev. C • 9/10 2
Figure 4. Mounting Remote Control Housing
5. Close the housing door. See Figure 4.
AUX300 Module Installation
• Insert the 4 hole harness from the AUX300 module into
the 4 pin plug on the control module. See Figure 5.
Figure 5. AUX 300 module installation
4. Place remote control inside housing. See Figure 3.
Figure 3. Remote in Housing
Installation of Remote Control Housing
CAUTION! Risk of Fire! DO NOT install damaged or
modifi ed components
. Warranty will be voided if damaged
or modifi ed components are installed.
Kit components: One remote control, two #6 screws, two
wall anchors, 3 AAA batteries and one AUX300 module. If
batteries are properly installed the remote will turn on
1. Remove remote control components from packaging.
2. Remove battery cover from the back of the remote by
sliding it down and install 3 AAA batteries.
To prevent unintended operation when not using your fi re-
place for an extended period of time (summer months,
vacation, trips, etc):
• Remove batteries from remote control.
• Unplug switching adapter and remove back-up batteries.
3. Secure the remote control housing on a fl at wall sur-
face using the two screws and wall anchors provided.
See Figure 2.
Figure 2. Mounting Remote Control Housing
CONTROL MODULE CONTROL MODULE
AUX 300 CABLE AUX 300 CABLE
Figure 1. Temperature scale
Changing Temperature Scale
To change the temperature display between Celsius and
Fahrenheit, remove the battery cover from the back of the
remote control and slide the switch to your desired tem-
perature scale (see Figure 1). The screen will automati-
cally change the indicators on the room temperature and
set temperature portion.