HONDA 2-DOOR DX - Manual (Page 6)

6 of 12
AII 31246-31447 (0511) © 2005 American Honda Motor Co., Inc. - All Rights Reserved.
PRELIMINARY
5. Remove the steel glove box lower frame (two
washer-bolts.
6. Using diagonal cutters (and/or a utility knife), cut
out the dashboard-link at the glove box area.
7. Remove the passenger's heater duct (one hex
screw and two self-tapping screws), and remove
the harness connector clip.
8. Remove the blower motor assembly:
• Remove the three nuts, one flange bolt, and
the three washer-screws (black).
• Disconnect the white 14-pin connector at the
top of the blower motor, the white 2-pin
connector at the bottom, and the green 4-pin
recirc motor connector on the right side of the
motor.
• Pull the blower motor out past the three studs,
and tilt the assembly down. Rotate the
assembly toward the center of the vehicle and
down to remove it.
9. Remove the evaporator housing cover (nine
screws), and disconnect the 4-pin power transistor
connector. To reach the forward middle screw, you
will need a long Phillips #2 screwdriver
(150 mm/6" shaft).
GLOVE BOX
LOWER FRAME