Husqvarna 2009-01 - Manual (Page 8)

9
ASSEMBLY
1. Make sure the tension release lever is forward or
disengaged.
2. Place the belt over the pulley on the deck. Refer to
illustration for proper routing.
3. Move the tension release arm to the rear and
engage in the latch.
3
INSTALLING DRIVE BELT
Rear Of Deck
Idler Pulleys
Outer Pulley
Twist in Belt
Tension Release Arm
4
INSTALLING BELT COVERS
1. Place the deck belt shield on the deck over the
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the end
of the outer pulley cover.
4. Secure with knob.
Retainer
Knob
Outer Pulley Cover
Deck Belt Shield
Belt Cover Tab
Middle Chute Latch
5
TRIMMING MIDDLE CHUTE
1. Using the hacksaw, trim along the dashed line.
2. Locate the middle chute, flat washer, hood latch,
weld nut, lock washer and machine screw from kit.
3. Install in the appropriate hole at the upper end of
the middle chute, according to deck size.
Trim Line
Hood Latch
Weld Nut
Machine Screw
Lock Washer
Latch Location
Flat Washer
6
INSTALLING MIDDLE CHUTE
1. Place middle chute over the top end of the blower
assembly.
2. Latch middle chute to blower assembly.
Middle Chute
Blower Assembly