Husqvarna 2009-01 - Manual (Page 9)

10
2. Install the bagger mount tube to the rear guard
with 5 /
16
-18 x 3¼ bolts and flange nuts from kit.
NOTE: Depending on model, rear guard hole may
need to be drilled out to 5 /
16
" if kit hardware is too
large.
3. Install kit support straps on the outside of the
mount tube as shown in the illustration. Using a
5 /
16
-18 x 1¼ bolt, attach the front side of the strap
to the fender support. Do not add flange nut at this
time. Place the reinforcement plate to the outside
of the fender support. Secure with additional 1¼
bolt and fasten both bolts with flange nuts. Repeat
steps on opposite side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
4. Tighten all hardware.
ASSEMBLY
1. To select the right support straps to use, measure
the mower frame just behind the casters, as
shown.
7
INSTALLING BAGGER MOUNT
Reinforcement Plate
Mount Tube
Support Strap
For frames measuring 26" use support straps A,
for frames measuring 23" use support straps B.
A
B
Drill rear
guard hole to
5 /
16
" if needed
Rear Guard