Harbor Freight Tools 93012 User Manual
Page 5
Page 5
SKU 93012
For technical questions, please call 1-800-444-3353
3.
Maintain a safe working environment. Keep the work area well lit. Make sure there
is adequate surrounding workspace. Always keep the work area free of obstructions,
grease, oil, trash, and other debris. Do not use a power tool in areas near flammable
chemicals, dusts, and vapors. Do not use this product in a damp or wet location.
4.
Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Scroll Saw.
5.
Do not force the Scroll Saw. This tool will do the work better and safer at the speed
and capacity for which it was designed.
6.
Always unplug the Scroll Saw from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
7.
Never leave the Scroll Saw unattended while running. Turn power off if you have to
leave the Scroll Saw.
8.
Before each use, check all nuts, bolts, and screws for tightness. Vibration during
use may cause these to loosen.
9.
Keep extension cord off the ground and away from water.
10.
Always connect the Line Cord to a Ground Fault Circuit Interrupter (GFCI)
protected electrical outlet.
11.
Install this product on a proper surface. Locate on a flat, level, and solid surface
that is capable of supporting the weight of the Scroll Saw.
12.
Do not try to cut material too small to be securely held by hand. Cuts to hands can
occur.
13.
Avoid awkward hand positions where a sudden slip could cause hand contact
with the blade.
14.
When cutting a long piece of material, make sure it is supported off the table at
the same table height.
15.
Hold the workpiece firmly against the table.
16.
Do not feed material too fast while cutting.
17.
Use caution when cutting off round material such as dowel rods or tubing. They
have a tendency to roll while being cut causing the Blade to “bite.”
18.
If the blade binds in the workpiece when backing out of the cut, immediately turn
the saw power Off and carefully back material off Blade.
WARNING! People with pacemakers should consult their physician(s) before using
this product. Operation of electrical equipment in close proximity to a heart pacemaker
could cause interference or failure of the pacemaker.