Harbor Freight Tools 93012 - Manual (Page 9)

Page 9 SKU 93012 For technical questions, please call 1-800-444-3353
ASSEMBLY INSTRUCTIONS
Mounting Scroll Saw to Workbench
1. Pick a solid, wood workbench to mount the saw. The workbench must be stable, and
able to support the weight of the Scroll Saw and the material being cut.
2. Find the four 5/16 inch mounting holes in the Base (9) and mark through the holes for
drilling with a 3/8 inch drill bit. Remove Scroll Saw to drill holes.
3. Replace Scroll Saw over holes and mount with the following hardware (not supplied):
4 - Hex Head Screws, 1/4 inch x 20 x length required; 4 - Flat Washers, 9/32 I.D.; 4-
Lock Washers, 9/32 I.D.; and 4-Hex Nuts, 1/4 x 20.
4. Check that all Scroll Saw screws and nuts are tight before using the machine.
Check and Align Bevel Indicator
1. Loosen Table Lock Knob (44) and move the table until it is approximately
perpendicular (right angle) to the blade. See photo below.
2. Use a small combination square to set the table at 90 degrees to the blade.
3. Tighten the Table Lock Knob (44).
4. Loosen Pan Screw (14) holding the bevel Scale Indicator (13), and adjust Indicator to
point to “0” degrees. Retighten Pan Screw.
Note: The bevel Scale Indicator (13) is a guide and should not be relied upon for preci-
sion settings. Make practice cuts in scrap wood to determine if the angle settings are
correct.
OPERATING INSTRUCTIONS
Controls and Indicators
(1)
Workpiece Foot Lock
Knob (68)
Bevel Scale (15)
On / Off Switch (72) with
Locking Key
Variable Speed Knob (81)
Saw Table (53)
Blade Tension Knob (21)
Workpiece Foot (48)
Table Lock Knob (44)
Scale Indicator (13)
Vacuum Hose Connection
REV 05/05