Heath Zenith Motion Sensing Diecast Lantern HB-4190 Series - Manual (Page 2)

2 595-5770-05
INSTALLATION
For best performance, mount the fixture about
1.8 meters above the ground.
1. Remove
two nuts.
2. Remove
X-Bar.
Junction
Box
5. Attach X-Bar to
junction box
Due to the size and weight of the fixture, you
may find it helpful to have an assistant hold the
fixture in place while connecting the wires.
WIRING
One Motion Light
BLACK
WHITE
Two Motion Lights
BLACK
BLACK
WHITE
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the “pigtail”
with the GND screw on the X-Bar.
Black to black
MAX MIN
4. Set sensitivity on
fixture back to the
mid-position.
3. Tighten screws
finger tight.
SENSITIVITY
WARNING: Turn power off at circuit
breaker.
WHITE
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green “pigtail”. If you are unsure about
the grounding method, consult your local
building code.
CAUTION: DO NOT connect the RED wire
unless you want to control other lights from
the motion sensor.
White to white