haier HDC10SS - Manual (Page 7)

English
6
BEFORE USING FOR THE FIRST TIME
1. Unpack the unit.
2. Check the contents against the accessories list.
3. Remove all labels and the protective film.
4. Select a suitable location for the unit on a flat, stable surface close to
a power outlet.
Check to ensure all accessories are included and the unit is not dam-
aged. Be sure the filter and filter basket are assembled properly. Before
your first brew cycle, you will need to cycle the unit twice with water to
remove any sediment. Brew clean water by filling the reservoir up to the
MAX marker and follow the steps below (but do not use ground coffee
at this time), then pour the cycled water out of the carafe. Repeat 2
times. Remove and Clean carafe, Lid, Filter and filter basket thoroughly
with warm water.
OPERATION
Making Coffee
1) Open the flip up lid of coffee maker, use the carafe to fill the water
reservoir with cold water. Watch the left or right water level indicator
for your desired fill level. The water level should between the MAX
and MIN.
2) Place the filter basket in the filter basket in the unit. Make sure it is
properly seated. Then place the filter into the filter basket.
3) Add ground coffee to filter. One level tablespoon for every cup is
recommended, but you may adjust according to your personal taste.
4) Place the carafe on warming plate.
Note: Please make sure the carafe is properly seated on to the
warming plate.
5) Plug the power cord into the outlet, the LCD will
display “AM 12:00” (fig.1).
6) Press the “ON/OFF” button, the “RUN” indicator
lamp will now be illuminated. The brewing cycle
will now begin.