Henkel KEEN KF-100A - Manual (Page 3)

Recommended Spare Parts
When it is critical to have continuous operation of this unit;
we suggest having the following spare parts on hand:
Heating Element Assemblies
Thermostat
General Information
The model KF-100A is a portable hopper style flux oven capable of storing 125
pounds of welding flux. Flux is top loaded by way of a removable door and discharged
through a slide valve located on the bottom of the unit.
Safety Precautions
Read all instructions completely before attempting to operate this unit.
*** SAVE THESE SAFETY INSTRUCTIONS ***
To reduce the risk of electrical shock, fire, or personal injury follow the guidelines below:
• Before connecting unit to a power source, be sure the voltage supplied is the same as that specified on
the nameplate of the unit.
• Check outlet to ensure proper grounding of the electrical cable. Have a licensed electrician check the
A/C power outlet if you are not sure.
• Use this unit for its intended purpose as described by literature.
• Make sure power cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to stress of heat, oil, or sharp edges. Do not close doors on the cord.
• To reduce the risk of damage to the electric plug and cord, disconnect by plug rather than by the cord.
• Do not use this unit if cord or plug is in poor condition. If it has been exposed to weather or immersed
in water, have a qualified serviceman inspect and replace parts as necessary.
• WARNING! NEVER HANDLE PLUG, CORD, OR UNIT WITH WET HANDS OR WHILE
STANDING IN WATER.
• Use special care when moving heavily loaded units.
• Do not store combustible material on or around the unit.
• Do not operate this unit empty.