6operation – Harman Stove Company Conquest Gas Stove User Manual
Page 6
6
OPERATION
15. Set the High-Low Regulator to desired setting:
Turn fully counterclockwise for High and fully
clockwise for Low.
NOTE: An odor, resulting from the initial heating
of new materials in your heater, is not unusual
during the first fire, and in most cases will
disappear after an hour or two.
HOW TO TURN OFF THE FIRE
1. If using optional thermostat, set thermostat to
the lowest position.
2. Turn off the electric power to the blower.
3. Turn the ON-OFF switch on the upper right
rear of the stove to the OFF position.
4. Push in the gas control knob slightly and turn it
clockwise to “OFF.”
NOTE: The knob cannot be turned from “PILOT”
to “OFF” unless it is pushed in slightly. Do not
force it.
FLAME HEIGHT ADJUSTMENT
The flame height adjuster can be accessed by
opening the right side panel. Turn the adjuster clock-
wise to increase flame height and counterclockwise
to decrease. See above left. Adjusting the flames
too high will cause them to have black tips and cause
sooting. Sooting can cause the glass to get dirty.
Check flame height after five to ten minutes and re-
adjust if necessary.
Pilot Flames
If pilot flames are less than shown at left, use
pilot adjuster shown below, to increase flames.
Flame Height
Adjuster
Normal Flame pattern. Note: Flames will vary in height and
position depending on the placement and the amount of
ember wool.
Warning: The unit and
adjus ter may be hot.
Wear gloves and arm
protection if making
adjus tments while in
operation.
Pilot Adjuster