HotBrick Dual WAN Firewall VPN 1400/2 User Manual
Page 46
HotBrick, Tel: 305-398-0888, Fax: 305-398-5966
Tunnel to HotBrick Client – This describes an IPSec tunnel from a the VPN 1400/2 to the HotBrick
Client Software.
VPN Tunnel List– allows you to add a new tunnel or change an existing one on the list. The
router can support a maximum of 50 tunnels.
Tunnel Name– In order to distinguish the tunnels, you have to give the “Tunnel” a unique name.
Tunnel – Only after you enable the tunnel check box, the tunnel can be connected.
WAN port – You can choose WAN1, WAN2 or Any to make the VPN connection.
Local Security Network– These entries identify the private network on this VPN router. The
Network hosts can use the LAN-to-LAN connection. You can choose a single IP address, the subnet,
or a selected IP range to make VPN LAN-to-LAN connection.
Distinguished name remote client – this is an email format address. For example:
Preshared key - Choose a shared secret for this entry. They must be the same on both units.
Action
Connect – this button will initiate the tunnel
Submit Query – this button will add the policy
VPN Configuration – Advanced settings
When you use the tunnel to HotBrick unit or tunnel to HotBrick client configurations the
Advanced Settings a ren’t required. They are only required for configuring an IPSec tunnel to a third
party unit.
46