HP MP200 - Manual (Page 22)

18 19
Wireless LAN setup: Before configuring the wireless network, insert the USB Wireless
Adapter into one of the USB 2.0 ports on the front of the mp200.
To setup the wireless connection, the mp200 will walk you through the steps below.
During each step, you can press the “OK” button to continue, or press the “RETURN”
button to go back to the previous step.
Connection
Profile
Peer to Peer
Ad Hoc
Infra AP
Get SSID
(Scan WLAN)
1. Setup SSID
2. Security
Enter the key
Enter the key
DHCP
FIX IP
FIX IP
Wireless Wireless Setup Security Setup IP Setup Profile
OK
OK
Profile: Choose one profile to edit or apply. The saved profile can be applied later. To
apply the profile, choose it and press blue button to apply. In the first setting, choose
“Connection 1” and press the “OK” button to continue.
Connection: Select to use either the “Infrastructure (AP)” or “Peer to Peer (Ad Hoc)”
modes. If you have a home router, you would typically choose “Infrastructure (AP)”.
If your home network does not include a router, then choose “Peer to Peer (Ad Hoc)”
mode.
The following wireless setup procedure is divided into two sections, depending on which
mode your wireless network uses (Infrastructure/AP vs. Peer to Peer/Ad Hoc).