Heath Zenith MOTION SENSOR LIGHT SL-7001 - Manual

© 2003 DESA Specialty Products™ 595-5291-04
OPERATION
Solar Powered
Motion Sensor Light
Model SL-7001
Features
• Turns on light when motion is detected.
• Automatically turns light off.
• Photocell keeps the light off during daylight hours.
• Battery Protection Circuitry. Protects against ex-
cessive overcharge and undercharge.
Requirements
• Do not turn the light on before the battery is fully
charged. Charge the battery by keeping the switch in
the OFF position and the solar collector pointed
directly at the noon sun for 3 sunny days. If not fully
charged, the unit will not work.
• When FULLY charged, the solar light will operate a
maximum of 15 days without sunlight. Actual operat-
ing time will vary depending upon how frequently the
light is triggered.
Mode: On-Time: Works: Day Night
Test 5 Sec. x x
Auto 30 Sec. x
Light
TEST
OFF AUTO
Put the sensor switch in the TEST
position.
AUTO
Battery
Case
Sensor
5 Mounting
Screws (2 sizes)
Put the sensor switch in the AUTO
position.
INSTALLATION
For best performance, mount the fixture about 8 feet
(2.4 m) above the ground.
❒
Mount Solar Panel Base on a solid surface using
three tapered screws. Adjust the panel to point
directly at the noon sun. Avoid obstructions such as
trees or buildings that may block sun light. Allow for
enough wire to reach the case. Keep ball joint at
bottom.
Note: You will want to re-aim the solar panel as
the seasons change to keep it pointed directly at
the noon sun.
Three Mounting Holes for Solar Panel Base
❒
Mount the Battery Case on a solid surface using
two round-head screws and the keyholes on the
back of the case.
Note: When first turned on wait about 1 minute for the
circuitry to calibrate.
Light
Solar Panel
TEST
OFF AUTO
3 3 /
4
"
TEST
This package includes: