HP 2000491 - Manual (Page 71)

Connecting Video Out 65
Connecting V
ideo Out
Using the Remote Control with Your TV
You can use the HP Digital Entertainment Center remote
control to change channels and adjust volume if you have
a cable box or satellite receiver, have installed the
Infrared Transmitter cable, and have configured the
remote control after initial turn on.
Always point the HP Digital Entertainment Center remote
control at the HP Digital Entertainment Center front panel.
The infrared remote sensor, behind the front panel
window, receives signals from the remote control.
The HP Digital Entertainment Center includes one or two
Infrared Transmitter cables (IR blaster) that are required to
control one or two set-top boxes. You must carefully
position the Infrared Transmitter cable tip on the set-top
box to ensure the set-top box receives the IR signal from
the HP Digital Entertainment Center. See “Infrared
Transmitter Installation” on page 92.
Using the SCART Adapter
The supplied SCART adapter enables you to connect the
composite video output of your HP Digital Entertainment
Center to TVs that only accept a 20-pin SCART input.
In addition to the composite video input, the SCART
adapter enables you to connect left and right channel
audio signals to your TV.
The SCART adapter is shown in the following graphic.
.