Honeywell TE218ELW - Manual (Page 6)

10 11
1. Press to view the previous single alarm time and arm
the alarm.
2. Press to disarm the single alarm and “OFF” will be
displayed.
3. When the single alarm time is displayed, press and hold
ALARM ON/OFF for 3 seconds;
4. The alarm hour digit will flash, then press or to adjust
the desired hour.
5. Press ALARM ON/OFF again, the alarm minute digit
will flash, then press or to adjust the desired minute.
6. Press ALARM ON/OFF again and the single alarm is
set with the icon “ ” on the display.
WEEKDAY ALARM SETTING
1. Press to view the previous weekday alarm time and arm
the alarm.
2. Press to disarm the weekday alarm and have the
display read “OFF”.
3. When the weekday alarm time is displayed, press and hold
ALARM ON/OFF for 3 seconds;
4. The alarm hour digit will flash, then press or to adjust
the desired hour.
5. Press ALARM ON/OFF again, the alarm minute digit
will flash, then press or to adjust the desired minute.
6. Press ALARM ON/OFF again and the weekday alarm is
set with the icon “ ” on the display.
SINGLE ALARM SETTING
Press ALARM ON/OFF to select the single alarm. If the
alarm is disarmed, the alarm time will be displayed as “OFF”.
If you choose not to set the SINGLE ALARM press
ALARM ON/OFF again to advance to the PRE-ALARM
setting procedure.
* Pre-Alarm
If the remote temperature (channel 1) is 32˚F or below,
the pre-alarm feature will be activated. The pre-alarm
time interval can be set for 15, 30, 45, 60, 75 or 90
minutes before the weekday or single alarm time.
This alarm will only sound if either the weekday or single
alarms are armed. It may warn you about the lower
temperature weather conditions and wake you up earlier in
case of a potential ice or snow. This alarm can be bypassed
during the set up if you choose not to use it.
If the calendar is displayed, pressing ALARM ON/OFF will
display the weekday alarm. Each press on ALARM ON/OFF
button will display the next available alarm in the sequence of
Weekday alarm, Single alarm and Pre-alarm.
Press MODE to return to the calendar display.
PRE-ALARM SETTING
Press ALARM ON/OFF to select the pre-alarm time. If the
alarm is disarmed, the alarm time will be displayed as “OFF”.
The pre-alarm can be set only if the weekday alarm or the
single alarm is set. If you choose not to set the PR E -AL AR M
press ALARM ON/OFF again to exit the setting procedure.
1. Press to view the previous pre-alarm time and arm
the alarm.
2. Press to disarm the pre-alarm time and have the display
read “OFF”.
3. When the pre-alarm time is displayed, press and hold
ALARM ON/OFF for 3 seconds;
4. The minute digit will flash, then press or to adjust
the desired pre-alarm period in the sequence of 15, 30, 45,
60, 75, 90 minutes.
5. Press ALARM ON/OFF again and the pre-alarm is set
with the icon “PRE-AL” on the display.
USING THE ALARM AND SNOOZE
When the alarm sounds, press the LIGHT/SNOOZE key
to temporarily stop the alarm. After depressing LIGHT/
SNOOZE , the alarm sound will resume in 5 minutes. If the
alarm is not disabled after that, it will sound for 4 more
minutes and then will stop by itself.
Press ALARM ON/OFF to disable any alarm.
W
S