Harbor Freight Tools CENTRAL MACHINERY 65345 - Manual (Page 15)

Page 15 SKU 65345 For technical questions, please call 1-800-444-3353.
FIgurE N HEADSTOcK
Spur cENTEr
(12)
FAcEpLATE
(13)
HEADSTOcK
SpINDLE
(14)
BALANcE
WHEEL
(22)
The power Switch Safety Switch:
The Lathe features a yellow Safety 1.
Switch on the Power Switch (46) to
prevent unauthorized use. To turn
the Lathe on, plug the Power Cord
(45) into the nearest 120 volt, ground-
ed, electrical outlet.
Insert the Safety Switch into the
2.
Power Switch (46). Move the Power
Switch to the “ON” position. To turn
the Lathe off, move the Power Switch
to the “OFF” position. To lock the
Power Switch in the “OFF” position,
remove the Safety Switch and store it
in a safe location. (See Figure O.)
OpErATINg INSTrucTIONS
With the Power Switch (46) in its 1.
“OFF” position and the Lathe un-
plugged from its electrical outlet,
make all necessary adjustments to
the machine as previously discussed.
To set up a spindle turning opera-
2.
tion, mark both ends of the work-
piece by drawing diagonal lines from
corner to corner. The intersection
point of these two lines will indicate
the center of the workpiece.
(See Figure O.)
Use a wood mallet and punch to tap
3.
the point of the center of the work-
piece so that it leaves a center mark.
(See Figure O.)
Use a 1/8” drill bit to drill a 3/16” deep
4.
hole at the center mark on the work-
piece. (See Figure O.)
FIgurE O
pENcIL LINES
MArKED DIAgONALLY
AcrOSS cOrNErS
WOrKpIEcE
5. Cut the corners off the workpiece if it
is over 2” x 2” to make turning safer
and easier. (See Figure p.)
FIgurE O
pOWEr SWITcH (46)
FIgurE p