Harman-Kardon Car Stereo System - Manual (Page 5)

Wiring Diagram
Direct Connection of the 12-Volt Power Harness With
In-Line Fuse Holder
Use this method when you want a permanent power connec-
tion to the vehicle. Also, by connecting the harness’s red wire
to the ignition switch’s ACC terminal, Drive + Play will turn on
or off with the vehicle’s ignition (ACC) switch. An in-line fuse
holder provides protection for the unit.
IMPORTANT: Replace the in-line fuse only with one of the
same type and rating.
INSTALLATION 5
INSTALLATION
Auxiliary
Device
(optional)
Third-Party
CD Changer
Interface
(optional)
Text Display
Back Side
+12Vdc = yellow
CD Changer L/R In
Aux. L/R In Antenna In
2A Fuse
ACC = red
GND = black
Electronics Enclosure
Antenna Cable
(disconnect from
Head Unit/Radio)
Head Unit/Radio
or
or
or
or
Cell Phone,
Satellite Radio, etc.
iPod Cable
3.5mm Stereo Cable
(not included)
Line Out Cable
Wired
FM Adaptor
(optional)
Wireless
FM Transmitter
12-Volt
Power
Harness
12-Volt
Accessory
Power Cable
iPod
Control Knob
Tip = LEFT
Sleeve = GROUND
3.5mm Stereo
Mini-Plug Cable
RIGHT = Ring
Audio Input/Output Jacks
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 5