Harman-Kardon Car Stereo System - Manual (Page 8)

Installing Components
Installing the Control Knob (continued)
2. At the base (below the cable), using the 1.5mm hex key,
loosen (but do not remove) the hex setscrew.
3. To install the Control Knob with adhesive tape, perform
the following steps or skip to step 4:
a. Insert the mounting plate, rotate it 180°, and tighten
the hex setscrew.
b. At the site, wipe the surface and exposed mounting
plate with one of the enclosed alcohol pads. Allow both
to dry.
c. Remove the protective tape from one side of one of the
enclosed adhesive pads, and press the pad against the
mounting plate.
d. Remove the remaining protective tape, and press and
hold the Control Knob to its site for 5 seconds.
4. To install the Control Knob with mounting screws, perform
the following steps:
a. At the proposed site, place the mounting plate and
rotate it so that the arrow will point toward the hex
set-screw at the back of the base after it’s mounted.
b. Holding the mounting plate in position, fasten it to the
surface with three enclosed mounting screws.
c. Using the mounting plate’s center hole as a template,
drill a hole through the mounting surface and pass the
Control Knob’s cable through the hole.
d. Place the Control Knob on the mounting plate (180°
from its final position), and then rotate it a half-turn to
the final position. Tighten the hex setscrew at the back
of the base.
5. Route the attached cable to the Electronics Enclosure.
Installing the iPod Cable
Route the iPod dock connector cable to the chosen iPod site
(e.g., the center console compartment or the glove box). Be
sure to leave enough cable exposed to make connecting and
disconnecting the iPod easy.
Making the System Connections
With all power off, refer to the Wiring Diagram on page 5 and
make only the power, ground and audio signal connections
that apply to the scheme you have chosen. After verifying all
connections including the iPod, proceed to the next section,
Operating Drive + Play.
OPERATING DRIVE + PLAY
Distraction Warning
Do not connect or disconnect your iPod or program Drive + Play
while driving. Always pull off the road and park in a position that
you are absolutely sure presents no risk before browsing your
iPod or adjusting the settings on your Drive + Play. Always obey
all traffic laws while driving.
Overview
8 INSTALLATION/OPERATION
Mounting
Plate
Control Knob
With 0° Base
Adhesive
Pad
Mounting
Plate
Control Knob
With 0° Base
Arrow
Next/Fast Forward
Press Once to Play Next Track
Select
Press Once to Choose
Highlighted Menu Item
Scroll Ring
Scroll Right Once to Next Menu Item
Scroll Right and Hold to Jump Forward
In Now Playing, Scroll Right to
Fast Forward
Scroll Ring
S croll Left Once to Last Menu Item
Scroll Left and Hold to Jump Back
In Now Playing, Scroll Left to
Fast Rewind
Menu
Press Once to
Jump to Last Screen
Play/Pause
Press Once to Stop or
Resume Play of Current Track
Previous/Rewind
Press Once to Play Last Track
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 8