Hughes AN6-098P - Manual (Page 27)

Chapter 2 • Antenna parts and required tools
1037312-0001 Revision A
9
Inspecting the antenna
parts
The antenna kit for each radio type is shipped in two boxes, as
shown in Figure 2. The radio assembly is shipped separately. As
soon as possible, unpack and inspect the antenna parts and
hardware to make sure all parts have been received in good
condition.
Each main part is illustrated in the following sections, and the
small hardware parts are listed in Table 2 and Table 3 on page 19.
If any parts appear to have been damaged in transit, immediately
contact the freight carrier. If any parts appear to be missing or
damaged but not as a result of handling in transit, contact your
dealer or distributor.
Figure 2: Shipping container contents—main components
T0172017
The feed support tube and feed rods in the
two antenna kits, for the J-type or cradle-
type radio, are not interchangeable.
Antenna kit
(2 boxes)
Az/El and reflector
bracket assembly
Feed horn
Radio mounting adapter
Radio mounting brackets
Waveguide transition
(attached to feed horn)
Included in kit for J-type radio only:
Antenna reflector
Feed support tube
Feed rods
Radio
assembly
Not part of the antenna kit
J-type or cradle-type
Box 1 of 2
Box 2 of 2
Small hardware parts such as fasteners are also
included in the boxes, as detailed in Tables 2 and 3.