HONDA 08B15-S9V-100 - Manual (Page 11)

© 2003 American Honda Motor Co., Inc - All Rights Reserved. AII 25886 (0308) 11 of 14
37. Remove the fuel lid door opener lever, then
remove the left front door sill trim (three clips and
two retaining tabs).
38. Remove the weatherstrip from the left kick panel.
Remove the upper clip from the left kick panel,
then pull the left kick panel out toward you to
release the retaining clip.
39. Get two EPT sealers. Using scissors, cut two
EPT sealers into six pieces. Wrap the them
around the antenna unit cable at the
measurements shown.
40. Using isopropyl alcohol on a shop towel, clean the
bottom of the antenna unit. Remove the backing
from the 60 x 60 mm double-sided adhesive tape,
and attach it to the bottom of the antenna unit.
CLIP
CLIP
LEFT KICK
PANEL
WEATHERSTRIP
CLIPS (2)
CLIP
FUEL LID DOOR
OPENER LEVER
RETAINING
TAB
LEFT
FRONT
DOOR SILL
TRIM
ANTENNA UNIT
CABLE
ADHESIVE
BACKING
(Remove.)
ANTENNA
UNIT
ANTENNA
PLATE
Clean with
isopropyl alcohol.
EPT SEALER
60 x 60 mm
DOUBLE-SIDED
ADHESIVE TAPE
Cut.
ANTENNA
UNIT
ADHESIVE
BACKING
(Remove.)
41. Using isopropyl alcohol on a shop towel, clean the
areas where the antenna unit and the antenna
plate will attach.
42. Remove the adhesive backing from the antenna
unit and the antenna plate, and attach them to the
dashboard in the area shown.
ADHESIVE
BACKING
(Remove.)
DASHBOARD
60 mm
60 mm
60 mm
60 mm
60 mm
200 mm