HONDA 08B15-S9V-100 - Manual (Page 13)

© 2003 American Honda Motor Co., Inc - All Rights Reserved. AII 25886 (0308) 13 of 14
2N27080M
47. Continue routing the antenna unit cable alongside
the vehicle harness, and out through the hole in
the floor carpet under the driver's seat. Secure the
antenna unit cable to the vehicle harness with four
wire ties in the area shown.
Installing the Receiver Unit and FM Modulator Unit
48. Install the receiver unit to the unit bracket with the
four 4 x 8 mm washer-screws, and four 4 mm
flange nuts.
49. Install the FM modulator unit tn the unit bracket
with the two 4 x 8 mm washer-screws.
50. Get the DIN cable. Plug the DIN cable into the FM
modulator unit and the receiver unit.
FM
MODULATOR
UNIT
UNIT
BRACKET
4 x 8 mm
WASHER-
SCREWS (4)
RECEIVER
UNIT
4 mm
FLANGE
NUTS (4)
4 x 8 mm
WASHER-
SCREWS (2)
FM
MODULATOR
UNIT
RECEIVER UNIT
DIN CABLE
UNIT
BRACKET
2N27070M
ANTENNA
UNIT CABLE
WIRE TIES
FLOOR
CARPET
VEHICLE
HARNESS VEHICLE
HARNESS
HOLE
FM
MODULATOR
UNIT
RECEIVER UNIT
ANTENNA
UNIT CABLE
SUB
ANTENNA
CABLE
SUBANTENNA
CABLE
XM RADIO
HARNESS
3-PIN
CONNECTOR
4-PIN
CONNECTOR
FRONT
FM
MODULATOR
UNIT
CABLES
51. Position the unit assembly under the driver’s seat.
Plug the XM radio harness 4-pin connector and
the antenna unit cables into the receiver unit. Plug
the XM radio harness 3-pin connector, the display
module cable, and the subantenna cables into the
FM modulator unit.
52. Wrap one EPT sealer around the subantenna
cables.
EPT SEALER
DISPLAY
MODULE
CABLE