HighPoint Technologies 2680 - Manual (Page 5)

Rocket RAID 2680 FreeBSD Installation Guide
- 3 -
If using USB disk, insert it into the USB port. Assume the USB disk’s name is disk1
and driver modules are located at the first partition of disk1 in system, then type in
" load disk1s1:rr2680-x.x " (without quotation mark). If whole USB disk is formatted
as one partition, i.e. format the USB disk directly without partitioned, type in " load
disk1:rr2680-x.x " (without quotation mark) and then press enter.
To confirm USB disk name, type lsdev command.
In the following document we assume the driver diskette is inserted into the
on-board’s floppy controller.
for FreeBSD 6.0-RELEASE
ok load disk0:rr2680-6.0.ko
for FreeBSD 6.0-AMD64-RELEASE
ok load disk0:rr2680-6.0-amd64.ko
for FreeBSD 6.1-RELEASE
ok load disk0:rr2680-6.1.ko
for FreeBSD 6.1-AMD64-RELEASE
ok load disk0:rr2680-6.1-amd64.ko
for FreeBSD 6.2-RELEASE
ok load disk0:rr2680-6.2.ko
for FreeBSD 6.2-AMD64-RELEASE
ok load disk0:rr2680-6.2-amd64.ko
for FreeBSD 6.3-RELEASE
ok load disk0:rr2680-6.3.ko
for FreeBSD 6.3-AMD64-RELEASE
ok load disk0:rr2680-6.3-amd64.ko
for FreeBSD 7.0-RELEASE
ok load disk0:rr2680-7.0.ko
for FreeBSD 7.0-AMD64-RELEASE
ok load disk0:rr2680-7.0-amd64.ko
4) After the driver has been loaded, remove the floppy diskette from the (USB) floppy
drive or remove USB disk from USB port.
5) Type in "boot" and continue the installation as normal. You can refer to FreeBSD
installation guide.