Harbor Freight Tools 99741 - Manual (Page 9)

For technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
SKU 99741 PAGE 9
SPecIFIcatIOnS
Electrical Requirements 120 V / 60 Hz / 13 A
35 Ft. Long Power Cord
Water Pressure 1,600 PSI
Flow Rate 1.6 GPM
Water Supply Required 3-4 gPm minimum
Hose Length 19 Ft.
unPackIng
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
aSSemblY
read the entIre ImPOrtant
SaFetY InFOrmatIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO PreVent
SerIOuS InjurY
FrOm accIdental
OPeratIOn:
before performing any
inspection, maintenance, or
cleaning procedures:
turn the Power Switch of a.
the equipment to its “OFF”
position.
unplug the equipment from its b.
electrical outlet.
Shut off water supply. c.
Safely discharge all residual d.
water pressure.
disconnect water supply e.
hose.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Check the Inlet Strainer for any block-
1.
age, including packaging debris. The
Pressure Washer may be shipped
with a plastic plug in the Inlet.
Position the rear of the Handle above
2.
the rear of the Pressure Washer
body. Connect the Suction Tube from
the top of the Pressure Washer body
to the connector on the bottom of the
Detergent Bottle in the Handle. Make
sure that the Suction tube does not
bend or get pinched during assembly.
Lower the Handle onto the Pres-
sure Washer Body. Then secure the
Handle to the Pressure Washer body,
using the Screws provided.
Insert the Spray Wand into the Wa-
3.
ter Gun, and twist the Wand into the
Extension until the Wand locks in
place. Pull the Wand to make certain
it is secure.
Attach the High Pressure Hose to the
4.
Outlet Port on the front of the Pres-
sure Washer.
Attach the female part of the Quick
5.
Connector Set to the Supply Port on
the back of the Pressure Washer. At-
tach the male part of the Quick Con-
nector Set to a heavy-duty garden
hose (not included). Then, pull back
on the collar on the Female quick
connector and insert the male Quick
Connector.