Hitachi COMPAQ 8000 - Manual (Page 37)

b. Insert the new battery and position the clip back into place.
Figure B-3 Removing a Coin Cell Battery (Type 3)
NOTE: After the battery has been replaced, use the following steps to complete this procedure.
9. Replace the access panel.
10. If the computer was on a stand, replace the stand.
11. Reconnect the power cord and turn on the computer.
12. Reset the date and time, your passwords, and any special system setups, using Computer Setup.
13. Lock any security devices that were disengaged when the computer cover or access panel was
removed.
ENWW 31