Hitachi COMPAQ 8000 - Manual (Page 42)

4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION: Regardless of the power-on state, voltage is always present on the system board as
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. If the computer is on a stand, remove the computer from the stand.
6. Remove the access panel and front bezel.
7. Remove the black screw on the front of the chassis behind the bezel. The screw is located next to
the optical drive and is labeled "BEZEL."
Figure C-8 Retrieving the Front Bezel Security Screw
8. Replace the front bezel.
36 Appendix C Security Lock Provisions ENWW