HTC IRIS100 - Manual (Page 110)

110 Appendix
Adapter/Charger
Use the Correct External Power Source
A product should be operated only from the type of power source indicated on the electrical ratings label.
If you are not sure of the type of power source required, consult your authorized service provider or local
power company. For a product that operates from battery power or other sources, refer to the operating
instructions that are included with the product.
The AC Charger designed by UT Starcom for this unit requires the use of a standard 120 V AC power source for
device operation.
Never attempt to disassemble or repair an AC charger. Never use an AC charger if it has a damaged or worn
power cord or plug. Always contact a UT Starcom authorized service center, if repair or replacement is
required.
Never alter the AC cord or plug on an AC charger. If the plug will not fit into the available outlet, have a proper
outlet installed by a qualified electrician.
Never allow any liquids or water to spill on an AC charger when it is connected to an AC power source.
Always use the authorized UT Starcom AC charger to avoid any risk of bodily injury or damage to your cellular
phone or battery.
Never attempt to connect or disconnect the AC charger with wet hands. Always unplug the AC charger from
the power source before attempting any cleaning. Always use a soft cloth dampened with water to clean the
equipment, after it has been unplugged.
Handling the cord on this product or cords associated with accessories sold with this product, will expose you
to lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash
hands after handling.
Always disconnect the travel charger or desktop charger from the power source when it is not in use.