Harbor Freight Tools 94531 - Manual (Page 8)

SKU 94531 For technical questions, please call 1-800-444-3353 PAGE 8
OutDOOR uNIt FEAtuRES
cAMERA
SPEAKER
lABEl AREA
cAll ButtON
MIcROPHONE
OutDOOR uNIt
(11)
FIguRE E
to ensure the Mounting Plate is straight and level before tightening the Screws.
(See Figure D.)
to connect the Wiring:
Note: The Outdoor Unit (11) is factory pre-wired with approximately fifty feet of Tele-
phone Cord (6). If more length is required between the Indoor Unit (1) and Out-
door Unit, use RVV5 x 0.5 mm 2 cord (not included). (See Assy. Diagram.)
WARNINg! Avoid accidental electrical shock. If running the Telephone
Cord (6) within wall, floor, or ceiling spaces from the Outdoor Unit (11) to the
Indoor Unit (1) check hidden areas within the spaces to avoid cutting into live
electrical wires, gas and water pipes. (See Assy. Diagram.)
Place the Outdoor Unit (11) in its Outdoor Unit Mounting Plate (7), and secure the
Outdoor Unit to the Mounting Plate by tightening the two Screws (8).
(See Figure D and Assy. Diagram.)
Hang the Indoor Unit (1) on its Indoor Unit Mounting Plate (4).
(See Figure c
and Assy. Diagram.)
Run the Telephone Cord (6) from the Outdoor Unit (11) to the Indoor Unit (1).
Then, connect the plug of the Telephone Cord to the receptacle on the Indoor
Unit. (See Assy. Diagram.)
Connect the plug of the AC Adapter (3) to the power input socket on the Indoor
Unit (1). Then, plug the AC Adapter into the nearest 120 volt, grounded, electri-
cal outlet. (See Assy. Diagram.)
Note: The Video Doorphone may also be wired to control an electronic door lock (not
included). Refer to the “Electrical Schematic” in this manual for wiring instruc-
tions.
1.
2.
3.
4.
5.