Hitachi DV-S522U - Manual (Page 15)

-E14-
ENGLISH
PAUSE/ST
EP
PRE
V NE XT -TU
NE TUN
E+
REV
SLOW
FWD
SLOW
CLEAR
TRIM
SOURCE TU/BAND
RETURN DISPLAY PROG
TV CH TV VOL
TV VOL TV CH TV/VIDEO
LAST MEMO REPEAT
SEARCH MODE
TV POWER
ENTER
SHIFT
S E T UP
T O
P
M EN
U SU
BT
IT LE
M EN
U
0
8 7 9
+10
5 4 6
2 1 3
ANGLE A.REPLAY ZOOM
AUDIO SLEEP
TIMER ADJUST SET/CLEAR
CLOCK
1
SHIFT
CLOCK
2
PAUSE/ST
EP
PRE
V NE XT -TU NE
TUN
E+
REV
SLOW
FWD
SLOW
CLEAR
TRIM
SOURCE TU/BAND
ENTER
SHIFT
S E T UP
T O
P
M EN
U SU BT
IT LE
M EN
U
0
8 7 9
+10
5 4 6
2 1 3
ANGLE A.REPLAY ZOOM
AUDIO SLEEP
TIMER ADJUST SET/CLEAR
CLOCK
SHIFT
ADJUST
3, 5, 7
4, 6
Example: To set “PM 6:30” (Using the remote control)
1. Press [ z /I]. The STANDBY indicator goes off.
2. Press [CLOCK] while holding [SHIFT] down.
“AM 12:00” blinks.
3. Press [ADJUST] while holding [SHIFT] down.
The “hours” display blinks.
ADJUSTING THE CLOCK
4. Press [NEXT/TUNE+] or [PREV/-TUNE] to set the “hours”.
5. Press [ADJUST] while holding [SHIFT] down.
The “minutes” display blinks.
6. Press [NEXT/TUNE+] or [PREV/-TUNE] to set the “minutes”.
7. Press [ADJUST] while holding [SHIFT] down.
The clock starts.
• The time can be set accurately by pressing [ADJUST] while
holding [SHIFT] down when a time signal is heard.
To display the clock during operation
Press [CLOCK] while holding [SHIFT] down to display the clock.
(If leave it, the original display returns after approximately 15
seconds.)
Press [CLOCK] again while holding [SHIFT] down to return to the
original display.
Note:
If a power failure occurs, reset the clock again.