Hitachi DV-S522U - Manual (Page 36)

-E35-
PHONES
POWER/STANDBY FM MODE VOLUME
f /TUNE - e /TUNE + d /PRESET c /MEMO
SURROUND BASS SOUND SOURCE
k a n q OPEN/ CLOSE
2, 4 3
TIMER ADJUST SET/CLEAR
CLOCK
VOLUME
TEST TONE
FUNCTION
FM MODE PRESET
SOUND BASS SURROUND
+ - MUTE
TU/BAND
0 +10
3
PHONES
POWER/STANDBY FM MODE VOLUME
f /TUNE - e /TUNE + d /PRESET c /MEMO
SURROUND BASS SOUND SOURCE
k a n q OPEN/ CLOSE
1 2
PROG.
MHz
PROG.
MHz
MHz
TEST TONE
SOURCE
FM MODE PRESET
SOUND BASS SURROUND
MUTE
TU/BAND
0
8 7 9
+10
5 4 6
2 1 3
ANGLE A.REPLAY ZOOM
AUDIO SLEEP
TIMER ADJUST SET/CLEAR
CLOCK
VOLUME
2
1
Number
buttons
TU/BAND
FM MODE VOLUME
f /TUNE - e /TUNE + d /PRESET c /MEMO
SURROUND BASS SOUND SOURCE
k a n q OPEN/ CLOSE
FM MODE
DV-RM522
TEST TONE
SOURCE
FM MODE PRESET
SOUND BASS SURROUND
MUTE
TU/BAND
VOLUME
FM MODE
Manual presetting
1. Tune in the station to be preset as described in “Automatic/
Manual Tuning”.
2. Press [ c /MEMO].
“PROG.” blinks.
3. While “PROG.” is blinking, press [ d /PRESET] (or [PRESET]
on the remote control) to select the channel to be preset.
•
In this example, the channel is “9”.
4. While “PROG.” is blinking, press [ c /MEMO].
• In this example, “103.1 MHz” FM station is preset on FM
channel 9.
5. Repeat steps above to add more preset stations.
• When presetting a new station, the previous preset station is
cleared.
Listening to Preset Stations
1. Press [SOURCE] (or [TU/BAND] on the remote control) to
select FM or AM.
2. Press [ d /PRESET] (or [PRESET] on the remote control)
briefly to select the desired channel.
•
The number buttons on the remote control can also be
used.
Example: To select No.9, press [0], then [9].
Note: No not press the [+10] button.
Preset scan tuning
1. Press [SOURCE] (or [TU/BAND] on the remote control) to
select FM or AM.
2. Press [ d /PRESET] (or [PRESET] on the remote control)
for at least 1 second.
•
The channel number appears.
• The preset stations are selected in sequence for
approximately five seconds each.
3. Press [ d /PRESET] (or [PRESET] on the remote control)
when the desired station has been selected. Preset scanning
will stop.
To receive FM stereo broadcasts
Make sure that “MONO” is not displayed. If “MONO” appears,
press [FM MODE] to turn the “MONO” indication off.
“ST” appears when an FM stereo broadcast is received.
•
If the signal from an FM stereo station is weak and reception
is poor, press [FM MODE] to change to monaural reception.
The reception may be improved, but the sound will be
monaural.