Hunter Fan CARE FREE 34200 - Manual (Page 4)

©2008 Hunter Fan Co. 41785 Rev 05-06-2008 4
Power
pack
Tank Cap
Cut-out area of
power pack
NOTE: Do not carry the Water Tank by the exhaust vents. See
Figure 7.
9. Carrying the Water Tank by the two upper handles on the
top of the Tank, position the Water Tank so that the notch in
the back fits over the power supply cord and the Tank Cap in
front fits into the cut-out area of the Power Pack. See Figure
6.
Figure 6
10. If the Water Tank is properly seated, you will see air
bubbles flowing up into the tank. If you do not see air
bubbles, reposition the Water Tank as instructed above.
Make sure the Power Knob is set to OFF and plug the
humidifier into the wall outlet.
CAUTION: Never plug in the humidifier while your hands are
wet, as electric shock could occur.
11. Thread the power cord through both power cord clips on the
back of the humidifier.
12. Turn the Power Knob to the desired setting.
NOTE: If the Water Tank is not seated properly on the Power
Pack, it will not turn on.
Exhaust
Vents
Figure 7
Do not carry the
water tank by the
exhaust vents.
Upper
Handle
Operating Your Humidifier
1. Adjustable Humidistat – Allows you to adjust the humidity
setting. See Figure 8.
Figure 8
Adjustable
Humidistat
Knob
• Turn the dial to the right to increase humidity.
• Turn the dial to the left to decrease humidity.
2. Power Knob – Allows you to set a desired speed level. See
Figure 9.
Turn the dial to set the speed to High, Medium. Low and Off.
See figure 10.
Power
Knob
Figure 9
high MEDIUM
LOW OFF
Figure 10