Hunter Fan CARE FREE 34200 - Manual (Page 5)

©2008 Hunter Fan Co. 41785 Rev 05-06-2008 5
NiteGlo™ Night
Light Control
(model 34203
only)
Figure 11
3. NiteGlo™ Night Light Control (model 34203 only): Turns the
night light ‘ON’ and ‘OFF’. The night light can be turned on
even if the humidifier fan is turned off. See figure 11.
Refilling The Water Tank
6. Carrying the Water Tank by the two upper handles on the
top of the Tank, position the Water Tank so that the notch in
the back fits over the power supply cord and the Tank Cap in
front fits into the cut-out area of the Power Pack. If the Water
Tank is properly seated, you will see air bubbles flowing up
into the tank. If you do not see air bubbles, reposition the
Water Tank as instructed above.
CAUTION: Never plug in the humidifier while your hands
are wet, as electric shock could occur.
7. Make sure the Power Knob is set to OFF and plug the
humidifier into the wall outlet.
8. Turn the Power Knob to the desired setting.
1. When the water level is low, turn the Power Knob to OFF
and unplug the humidifier.
2. Lift the Water Tank and take it to the sink or a tub to refill.
NOTE: Do not carry the Water Tank by the exhaust vents.
3. Turn the Water Tank over and unscrew the Tank Cap by
twisting it counterclockwise. See Figure 12.
Water
Tank
Tank Cap
Figure 12
4. Empty the Water Tank and refill it with fresh, cool water.
NEVER USE HOT WATER.
5. Replace the Tank Cap by screwing it clockwise onto the
Water Tank. See Figure 13.
Water
Tank
Tank Cap
Figure 13
Cleaning the Humidifier and the
Water Tank
Many regions have hard water with high concentrations of
minerals. When water evaporates from the Care Free
®
Ultra
Evaporative Humidifier, minerals may be left behind. These
minerals can form a hard white scale which can be removed by
following the cleaning instructions. The frequency of cleaning due
to mineral build-up varies depending on the quality of water you
have.
1. Turn the Power Knob to OFF and unplug the humidifier.
2. Remove the Water Tank and carry it to a sink or a tub.
Unscrew the Tank Cap by twisting it counterclockwise and
empty any water in the Water Tank.
3. Lift the Power Pack and locate the three tabs on the top of
the Funnel Pump Assembly. Press the three tabs in and
remove the Funnel Pump by pulling away from the underside
of the fan blade.