HSM 411.2 - Manual (Page 12)

Paper shredder HSM 411.2
12 english 0603
Electric motor overheated
• Red LED on membrane key-
board lights.
• Paper shredder switches off au-
tomatically.
• Allow paper shredder to cool
down for approx. 15 to 20 min.
Front door or inspection door on
the top of the machine is open.
• Red LED on membrane key-
board lights.
• Paper shredder stops automati-
cally.
• Close front door and inspection
door
• If the door is opened when the
cutting device is running, the do-
cument shredder must be started
again using the green button
after the door of the document
shredder has been closed.
Bag for shredded material full
• Red LED on membrane key-
board lights.
• Paper shredder stops automatically.
Reversing the cutting device
(“Reverse” button) is also possib-
le even when the shredded mate-
rial container is full.
• Insert new bag
Particle cutting devices are
equipped with a compacting
mechanism. Press the foot pedal
in the lower part of the cabinet to
shake up the collector sack and
reduce the volume of the partic-
les. Paper can be fed again.
CAUTION!
Empty the shredded material
container after the paper shredder
has been switched off, because
otherwise malfunctions of the cut-
ting system could occur when the
rocker switch is pressed several
times in succession
6. Troubleshooting
Pa per jam
You have fed in too much paper.
• Paper shredder jammed.
• Red LED in the key pad fl ashes.
• Paper shredder reverses auto-
matically.
• Pull paper out of the paper fee-
ding opening.
If material is not completely
pushed out, then
• Press dashed arrow button.
• Paper is pushed out.
• Pull paper out.
The cutting device is easily ac-
cessible once the inspection
door on the top of the machine is
opened.
CAUTION!
Injuries by cutting rollers are pos-
sible even when the paper shred-
der is idle.
Keep hands away from the cut-
ting system!
• Separate paper stack and feed
paper again.
• The shredding process is started
again with the green arrow but-
ton or by the light barrier (paper
feed).
CAUTION !
Do not press dashed arrow but-
ton and green arrow button alter-
nately forwards and backwards.
Cutting system can be damaged.