Heat & Glo Fireplace MTL-INSERT - Manual (Page 21)

21 Heat & Glo • MTL-Insert • 2145-900 Rev. G • 6/09
Log Set Assembly: LOGS-SXT E. Positioning the Logs
CAUTION: Logs are fragile! Carefully remove
the logs from the packaging.
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
1 1
2 2
5 5
4 4
3 3
6 6
PILOT PILOT BASEPAN BASEPAN BURNER BURNER
LOG #1 (SRV349-701): Place log #1 in the back of the insert. Locate the legs of the log outside the 3/8" tabs to either
side of the burner. Pull the log forward until the log is stopped by the back edge of the burner.
349-935 1/02
GRATE GRATE
TABS TABS
1 1 1 1