HONDA HF2315SBE - Manual (Page 13)

the wings (1a) are turned inwards.
Hook the upper part of the grass-catcher
frame (5) onto the brackets and centre it
up with the rear plate (2).
Adjust the position of the two brackets (1)
to the stop (6) so that, when turning the
grass-catcher frame, the pin (7) slots into
the seat (8) correctly.
Check again that the frame (5) is properly
centred with the rear plate (2) and that it
rotates correctly, as shown above, and
then fully tighten the screws (3) and the
nuts (4).
3.7 ASSEMBLING THE LEVERS FOR TIPPING THE GRASS-CATCHER
Position the lever axle (1) in the notch
of the two plates (2) and attach them
on the internal side of the grass-catch-
er supports (3), using the included
screws (4) in the sequence shown.
Connect the end of the rod (5) of the
lifting piston to the lever (6) with the pin
(7) and attach the two snap rings (8).
Before attaching the grass-catcher to
its supports, make sure that the tipping
lever moves properly.
HF2•••HTE
➤
EN 12 UNPACKING AND ASSEMBLY
1
2
3 3 4 4
4
1 5 8 7
8 6
4
1
5
5
6
1
8
7
1a
2