HONDA HF2315SBE - Manual (Page 31)

tain space in the lowest position, whereas it
does not function when in the highest position.
To change the position, unscrew end remove
the pin (1) then reposition the wheel (2) in the
upper or lower hole of the wale shown on the
diagram.
This work is to be done to
all four wheels, WITH THE ENGINE OFF AND
THE BLADES DISENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– engage the blades (
☛ 4.9);
– start moving forwards onto the grass area very gradually and with particular
caution, as previously described;
– adjust the forward speed and the cutting height (
☛ 4.6) according to the lawn
condition (height, density and dampness of the grass). On flat ground, these
general conditions can be followed:
High and dense grass - wet lawn 2,5 km/h
Average condition grass 4 ... 6 km/h
Low grass - dry lawn over 6 km/h
The speed is controlled in a gradual and progressive way by the pressure on
the drive pedal.
When cutting on sloping ground, the forward speed
must be reduced to ensure safe conditions (
☛ 1.2 - 5.5).
In any case, the speed should always be lowered if you note a reduction in engine
speed, since a forward speed that is too fast compared to the amount of grass
being cut will never mow the grass well.
Disengage the blades and put the cutting deck in the highest position whenever
you need to get past an obstacle.
̆
! WARNING!
HF2•••HTE HF2•••HME
➤
̆
! WARNING!
EN 30 HOW TO USE
2
1